Different behaviour between Processing and Arduino Serial Monitor

[glv]

@kodibeni

However, the buttons still not work.

I did have issues with buttons as well and it only worked here while connected to the Arduino.

I will explore later today…

I am not a CP5 user but may explore this further.

A related post without CP5:

Processing to Arduino Serial Library Example

I modified the existing “SimpleWrite” example to: save and check for the state of mouseOverRect() print state to console only writes serial data once a delay() to wait for Arduino to reset once connected to it; in my case, it is an Arduino Mega 2560 R3. I kept the spirit of the original example intact and left it as a “Simple Write” program. My edit of “SimpleWrite” example so it only sends data once: /** * Simple Write. * * Check if the mouse is over a rectangle and writes the status …

Sometimes it helps to isolate the problem.

:)