Arduino RFID and Processing Connection

[glv]

Hello,

Did the code example I provided for Arduino work with your Processing code?
You should see output similar to what I have.

The delay() was related to this:

Processing to Arduino Serial Library Example

I modified the existing “SimpleWrite” example to: save and check for the state of mouseOverRect() print state to console only writes serial data once a delay() to wait for Arduino to reset once connected to it; in my case, it is an Arduino Mega 2560 R3. I kept the spirit of the original example intact and left it as a “Simple Write” program. My edit of “SimpleWrite” example so it only sends data once: /** * Simple Write. * * Check if the mouse is over a rectangle and writes the status …

I edited my last post on this.

:)